P10221: Baja 1 (Baja Driveline Test Development)/public/
Table of Contents
Attendees: Brian Helm, Matt Tranter, Jeffrey Ryan,Chukwuchebem Orakwue
- Start time: : 6:00 pm
- End time: : 11:00 pm
- Set up dyno for demo tomorrow.
- We ran three times at full rpm.
- Broke grade 2 shear bolts twice.
- Broke 1 grade 5 shear bolt on the last run.
- Hub was stuck on output shaft of the engine. We had to use a hub remover to remove it.
- Update budget
- Make the gannt chart accurate.
- Demo on 2/11 at 8 pm.
- Figure out how to validate the pressure sensor.
- Start doing the poster.
- Make a 30 minute powerpoint presentation for week 10.
- Place dyno run summarys of edge.
- Work on final version of tech paper.(TEAM)
- Make a final document comparing each dyno run.
- Operating procedure(BRIAN)
- assembly plan (JEFF)