The image above shows the first user interface designed using Labview. It shows displays all of the required information, but it was just the initial setup. The block diagram was not yet created.
The image above displays the final GUI. This GUI shows all of the required information as requested by the customer. Only 1 plot was required, displaying both input and output voltage and current. The temperature values are displayed as thermometers with the values displayed accurately below the thermometers. All of the numbers are displayed in little blocks for clarity and to provide accurate readings. The GUI also contains the motor controller for the device, which allows the user to start up the motor instantly. All of this had to fit on one page, which posed a problem in earlier designs.